|
3#
樓主 |
發表於 2009-5-24 19:41:10
|
只看該作者
Dear sir :
2 g' ?$ ^! L8 u Thanks your reply.5 p- k- o9 c, f8 H; u& F; u
To confirm again ,
# @# { u* P! G' ?# {- h$ t! J 1. It means when I measure use Spectrum Analyser I need to set ' }. @8 ]7 Z: F. p
RBW=200Khz start=2Mhz stop=50Mhz,
W' o0 p$ q! D' r) j9 A" Z if measured power level >-30dBm then it's fail , <-30dBm it's pass.0 k. _. T# `3 h* l9 X# Q( b
Right ?
# h* o/ P: |0 ]" O: f6 b7 M p
! @$ @+ y) } f9 K 2. But my boss tell me it's need below -70dbm not -30dbm , I don't know why.. e- _# F; p' e" Q5 }% k+ J. K
If I transfer it to dbm/hz is -83dmb/hz ,it become more severe than -70dbm2 s4 [1 p5 y2 \& h/ J/ Y& p5 J4 V
and unit also different. \' c% \6 V4 o* F! [/ x$ j
I don't know which part is wrong ?
7 I* I9 x% p% N
2 B- y5 c S G3 [$ I. E Thanks. |
|